Using the safety functions

Timing diagrams

Timing diagram for STO-function without SBC


Timing diagram for STO-function with SBC-function


Truth table for digital inputs

Digital input STO-SBC 1 Digital input STO-SBC 2 Internal fault Safety Statusword Error entry
0 0 no 1  
0 1 no 1 “SfeDilvd”
1 0 no 1 “SfeDilvd”
1 1 no 0  

|1 |1 |no |0 | | +————————+———————–+————–+——————-+———–+ |0 |0 |yes |1 |“SfeFault” |+————————+———————–+————–+——————-+———–+

Diagnostic functions

Software diagnostics

The safety module has two integrated diagnostic functions:

  • Comparing safety digital input statuses. The fault is activated after 100ms discrepancy of the STO-SBC inputs. In case a fault is detected, the servo drive will stop the motor and indicate a fault “SfeDilvd” in the Error Report object.
  • During the activation of the STO-SBC function the servo drive verifies that the two channels of the module are internally operating correctly. In case an internal fault is detected, the servo drive will stop the motor and indicate a fault “SfeFault” in the Error Report object.

Hardware diagnostics

The STO-SBC feedback is a hardware feature that outputs a signal when both digital inputs have received the STO-SBC signal correctly.

STO-SBC status register

The Safety Statusword indicates the current state of safety functions and Safety Digital Input Diagnostics shows the state of the safety inputs.

Index Name Descriptions
0x6621 Safety Statusword


1 - Bit 1: STO status is the first bit of byte

2 - Bit 2: SBC status is the first bit of byte

STO/SBC status:

0: is not active

1: is active

0x2611 Safety Digital Input Diagnostics


1 - Input 1:

2 - Input 2:

Input 1/2:

0: Input is low

1: Input is high


Using the SBC function while running the motor may damage the brake due to mechanical stress. During normal operation it is recommended to activate STO-SBC after the motor has come to a halt e.g. by introducing a delay with an external safety logic device such as a safety timer. This way an equivalent of SS1 with time monitoring is implemented.


The STO-function does not provide electrical isolation from the mains supply. If electrical changes need to be carried out on the system (e.g. modifying the motor cabling), the servo drive shall be completely isolated from mains supply with a mechanical switch.