Technical Specifications

Power Specifications

Power Specifications

Node Size

Node 400

Node 1000

Maximum Peak Output Power

415 W

1,040 W

Maximum Continuous Output Power

415 W

1,040 W

Rated Supply Voltage

12-48 V DC

Maximum Supply Voltage

60 V DC

Minimum Supply Voltage

8 V DC

Maximum Input Current DC

9.6 A DC

24A DC

Maximum Phase Current RMS

13.2 A RMS

33 A RMS

Efficiency (at Maximum Power)

98 %

Brake control power output

0-48 V PWM Phase D

General specifications

General specifications

Supported Communication Standard

EtherCAT

Number of Phases

4

Supported Motors

1 x 3-phase BLDC-Motor and 1 active brake

Up to 2 Brushed DC Motors 1

Brake control voltage

0-48 V PWM Phase D

Analog Inputs

4 (2 x single-ended 0-10V, 2 x differential ±5V) 2

Digital IOs

4 × GPIO / SPI 3 / I 2 C 3 (3.3 V CMOS logic) 4

Encoder Connectors

2 x 4ch. RS-422

Supported Standard Encoder Interfaces

Incremental Encoder (ABI), HALL, BiSS-C, SSI, SPI 3, I 2 C 3

Incremental Encoder max frequency

1.4 MHz 5 (supports up to 14,000 rpm with a 4,096 resolution incremental encoder)

Hardware Protections

Overcurrent, Overvoltage, Undervoltage, Temperature

Compliance with standards

CISPR 11 Class B

IEC 61000-4-6

IEC 61000-4-3

IEC 61000-4-2

IEC 61000-4-8

Dimensions

70 x 40 x 21 mm

Weight

85 g (incl. Heatsink)

Operating temperature

0 to 50 °C

Storage Temperature

-35 to 85 °C

Max. installation altitude

2000 m

Humidity

5-85% rH

Sensors on-board

DC-BUS Voltage, DC-BUS current, Phase Voltage, Phase current (two phases measured, one computed), Temperature

1

Currently not supported by our standard software. Can be developed upon request, please contact sales@synapticon.com

2

All Analog Inputs can be configured as single-ended 0-5 V, 0-10 V, 0-20 V or differential ±5 V, ±10 V independently. Upon request only, please contact sales@synapticon.com

3(1,2,3,4)

Upon Request

4

Two Digital IO can be configured as 5.0 V CMOS logic. Upon request only, please contact sales@synapticon.com

5

Depends on the firmware used. Value given for v4.1