Object for BISS Encoder 1.
Object for BISS Encoder 2.
Object for SOMANET Sense REM 16MT Encoder.
Object for SOMANET Sense REM 14 Encoder.
Object for Incremental Encoder 1.
Object for Incremental Encoder 2.
Object for HALL Sensor 1.
Object for HALL Sensor 2.
Each sensor can have one of these functions: Commutation, Motion Control feedback and Monitoring .
It is of vital importance to have exactly one sensor configured for Commutation so that the shaft’s position is known to the system. It is also mandatory to use a sensor for Motion Control but this can be the same one as for commutation. In case your setup requires it, you can use a different sensor for Motion Control. Monitoring is optional.
For correct function it is necessary to provide the resolution of the sensor, this value is given in Inc/Revolution, please refer to your encoder’s data sheet.
Please keep in mind that manufacturers sometimes give this specification in differing units. If the resolution according to your data sheet is not given in Inc/Revolution please convert the value.
The time period between two position samples. This value is used to calculate the velocity.
The polarity represents the direction of rotation of the motor in comparison to the rotation of the encoder. If these directions don’t match, then the polarity is inverted.
In case your encoder supports multiturn functionality, the number of stored revolutions must be specified here.